Chevelle and Nova Rear Axle Pinion Yoke Drive Shaft "U" Bolt Mounting Set

Home > Chevelle Parts >

Price: $9.95

PART NUMBER: TRA-779

Qty:

Description

Chevelle and Nova Rear Axle Pinion Yoke Drive Shaft "U" Bolt Mounting Set

New correct design " U " bolt style mounts required to install your drive shaft U joint at the rear end axle. Because so many rear ends have been changed, rebuilt or altered, please make sure this is the version you need. The design goes through your non-threaded rear end yoke and you put a nut on the back side for mounting. From center to center measures about 1 and 3/8 inches. Includes; 2 U bolts, four nuts, and four lock washers.

* Fits non threaded yokes similar to pictured below with gap for U-bolt securing nuts:

Yoke is not included only pictured for reference.
** Note ~ This info is common but not always correct, again please double check your particular car. Over the years many cars have had a rear end swap.

67-69 10 bolt 8.2 rears used U bolt style
70-81 10 bolt 8.5 rears used strap style = TRA-778
67-68 12 bolt 8.75 rears used U bolt style
69-70 12 bolt 8.75 rears used strap style = TRA-778

PART NUMBER: TRA-779

Other Great Parts That You Might Need

Chevelle and Nova Rear Axle Pinion Flange Driveshaft U Joint Straps and Bolts

12 BOLT Rear End Axle Spider Gear Set

Price: $14.33

Add

Price: $191.95

Add

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Chevelle Parts
Chevelle Parts > Chevelle Suspension
Chevelle Parts > Chevelle Suspension > Chevelle Axle Parts
Nova Parts
Nova Parts > Nova Suspension
Nova Parts > Nova Suspension > Nova Axle Parts


1970 Chevelle Park Light Lens Screws Set	1964 - 1967 Chevelle Clutch Lower Adjusting Push Rod Assembly	1966 - 1972 Chevelle / Nova Wheel Bearing and Race, Front Outer	1968 Nova Big Block Water Pump, AC Delco
$7.95	$25.69	$11.95	$208.57